Program Ungo Sr6000 Remote Drivers Dash Or

Some vehicles are DIY programming while other require diagnostic programming.

See Photobroken keyring loops See pictures for an example of what you will receive.

Use the following programming routine to add transmitters to the vehicles security system or to change button assignments if desired.

Program Ungo Sr6000 Remote Drivers Dash Or

In order to enter Learn Routine, the ValetProgram push button must be plugged into the main brains Blue 2 Pin Port (Look for a small black push button located under the drivers dash or drivers kick panel somewhere).

The ValetProgram switch, plugged into the blue port, is used for programming.

There is a basic sequence of steps to remember whenever programming this unit.

Open a door and make sure the dome light is on.

Turn the ignition on to the RUN position or you may also start car.

Within 10 seconds, press and release the ValetProgram switch the number of times that corresponds to the desired channel (listed below).

Once you have selected the channel, press the switch once more and HOLD it.

The LED will flash and then the horn will chirp (if connected) to confirm the selected channel.

Do not release the ValetProgram switch.

You can advance from programming one channel to another by releasing the ValetProgramming switch and tapping it to advance channels and then HOLDING it.

For instance; you have programmed Channel 1 and you want to program Channel 2.

The LED will flash 2 times and the horn will chirp twice (if connected).

As before, do not release.

If you want to program Channel 3 after programming Channel 1, release the ValetProgram switch, press it twice and release it to advance to Channel 3.

The horn will chirp 3 times (if connected) and the LED will flash 3 times to confirm it is ready to receive the code from the transmitter.

Once the code(s) are learned, the ValetProgram push button can be released.

Programming mode will be exited if one of the following actions occurs: a.

ValetProgram switch is pressed too many times.

More than 15 seconds elapses between programming steps.

The horn will emit one long chirp when programming mode has been exited.

How to find out if this remote is compatible with your Vehicles installed RKE System If youre not sure your vehicle can use this remote, please ask questions or contact your local dealer first.

Check the back of your current or old keyless remote to match FCC ID Part s.

Contact your local dealer and tell them your VIN and ask what part FCC ID you need.

Your vehicle will be installed with one of the following keyless entry systems: a.

Standard Keyless Remote Packages: Installed at time of manufacture.

Optional Keyless Remote Packages: Installed by a dealer.

Aftermarket Keyless Remote Packages: Installed by previous owner or a caraudio shop.

No remote keyless entry system at all.

The above information can change which remote you need for your installed remote keyless system.

We ensure proper working condition of all previously used or new remotes through a serious of tests performed with the Santronics Testing device.

Each button is tested for functionality prior to shipment and then logged.

Please Note: Each remote and circuit board is UV idd prior to shipment All returns receive a UV ID inspection to verify originality of remote sent prior to refund or replacement.

All remotes sold on Keyless4u include working batteries.

B. Installed batteries are not tested for battery life- they are simply working.

Your order will be shipped w information on how to locate programming requirements for your vehicle.

How To Program Ungo Sr6000 Remote